The Source for Thermoformers, CNC Routers, Heat Sealers & More

Used 2003 USA FH5979-100

Machine Number: 16779

Size:

 
OR

Quick Overview

Used 2003 USA FH5979-100

16779

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

  • 16779
  • 16779
  • 16779
  • 16779

Details

Used 2003 USA FH5979-100 

AUTOMATED INCREMENTAL FEED CUTTING SYSTEM
A four-post hydraulic press producing 100 metric (110 U.S.) tons of cutting force, with two cylinders mounted over cross members linked end to end with torsion bars.  This mechanical balancing system ensures that the maximum cutting force of the press can be delivered anywhere on the bed of the press, and keeps the bed and bridge parallel even under asymmetrical (unbalanced) loads.  This hydraulic press can deliver its total force at any point in the down stroke.  
 
Model    2003  Used USA FH5979-100    
Cutting Force:  100 Metric (110 US) Tons    
Cutting Stroke:  4.3” (110 mm)    
Machine Bed :  59.1” D x 78.7” W (1500 x 2000mm)    
Effective Cutting Area:  57.1” D x 72.8” W (1450 x 1850mm)    
Main Motor:  20 HP    
Power:  220 Volt, 3 Phase, 60 Cycle  


Manual 4 Position Mechanical Stops – Low point stops ensure the precise bottom position and parallelism of the head on each cutting stroke.  There are four adjustable stops located in the head of the press.  They correspond to the four corners of the head.  When one stop is adjusted all stops are adjusted at the same time.

Pneumatic Die Mounting Rails Under the Head – The die rails hold the tooling under the head.  They are pneumatically operated and fully adjustable for easy die board change out.

2mm Steel Wear Plate on the Machine Bed

Automated Incremental Feeding System, including 
*Control and power feeding unit driven by timing belt
*236' (6 M) long inboard heavy-duty plastic roller stand
*157' (4 M) long outboard plastic roller stand
*197' (5 M) long Bakelite slide table

Oscillating Pad Shifter on the Slide Table – The oscillating pad shifter greatly improves the cutting pad life by moving the cutting pad after each cut.

2 HP Servo Motor Positioning System – The servo motor positioning system has a +/-0.004” positioning accuracy which means you will obtain very high material yields.  The system consists of an AC servo motor, encoder, and integrated drive unit.

Separate Sealed Hydraulic Unit – Is used to keep contamination out of the hydraulic fluid.

Touch Screen Operator Interface with Program Storage – The user friendly touch screen makes machine operation easy for any operator with the ability to store programs, recall programs, and change material specifications and feed distances all with the touch of a finger.  It also contains information from the operator’s manual on how to do a die setting, set the mechanical stops and trouble shooting.

Inboard and Outboard Hinged Safety Guards – NOTE: Seller does not warrant that its products conform with or satisfy the requirements of the Occupational Safety and Health Act of 1970 e.g. guarding and/or proper use of products shall be solely the Buyer's responsibility. 

Additional Information

Machine Number 16779
Inventory Code HPRS
Size 000